On the initial screen, select the Operating System. Once downloaded install it and run the application. Note we can manually install operating system image in that link also by scrolling down but that is beyond the scope of this post. Head over to the official raspberry pi software site and download the Raspberry Pi Imager according to your workstation OS. Insert your SD card in your card reader and attached it to your workstation or laptop. Once everything is set then we could proceed with the setup procedure. Your workstation or laptop where we will remotely connect with your raspberry pi.Power for your Raspberry Pi (Official or Mobile phone charger for Raspberry Pi Zero).SD Card ( prefereably 32 GB, I used 16 GB in my case).Raspberry Pi (I used Raspberry Pi Zero W).The following are the supplies needed in this post.

I am using Windows here as my workstation but you can use a Linux or Mac as well to follow along with this exercise.

Before we start the setup of our Raspberry Pi in headless mode then we need to prepare some supplies to follow along with this post.

Setting up headless raspberry pi zero w